Plastic waste is a significant environmental problem for almost all countries; therefore, protecting the environment from the problem is crucial. The most sensible solution to these problems is substituting the natural aggregates with substantial plastic waste in various building materials. This study aimed to optimise the mixed design ratio of cement brick containing plastic waste as aggregate replacement. Plastic cement brick mixtures were prepared by the incorporation of four different types of plastic waste such as polyethylene terephthalate (PET), high-density polyethylene, (...) low-density polyethylene and polypropylene into cement bricks with different cement contents (150, 300 and 450 g) and plastic replacement percentages (0, 3 and 6%). Compressive strength and water absorption of the plastic cement bricks were analysed using a statistical model through the response surface methodology. It revealed the optimum cement brick mixed design is C3-1% PET with the compressive strength of 27.50 MPa and water absorption of 1.16%. The optimised plastic cement brick also satisfied the general ASTM C62-17 requirements for building bricks despite the higher porosity observed by the scanning electron microscopy. The results from Fourier transform infrared spectroscopy analysis also showed that the addition of the plastic waste into cement brick was unlikely to modify the chemical compound within the cement brick mixtures. Thus, the proposed mathematical model can predict the required hardened properties of plastic cement bricks and could lead to greater utilisation of plastic waste in building materials. (shrink)

High grade chromite ore has been decreased constantly due to the importance of chromium element in industrial uses such as metallurgical, chemical, and refractory industries. Therefore, beneficiation of low grade has been more significant .Response Surface Methodology (RSM) is combination of statistical and mathematical methods used for modeling and analyzing problems. In this study, the Central Composite Design (CCD) was applied by using Design-Expert (version 6.0.5) for modeling and optimizing the effect of operating variables on the performance (...) of gravity separation via pilot plant shaking table for chromite ore. Three operating variables were studied, namely feed rate, tilt angle, and flow rate during the tests. The sample under study is low grade chromite ore, containing (30.21%, Cr2O3). The mathematical model equations of ANOVA model revealed that the grade of concentrate is more sensetive for feed rate (g/min) compered to water flow rate (l/min).whereas , recovery of concentrate is more sensetive for tilt angle compered to water flow rate (l/min) and feed rate (g/min). Optimized responses for the beneficiation process were found at concentrate with 48.52% Cr2O3 in with 83.09% recovery and it was achieved at water flow rate 15.33 l/min, tilt angle 2.16 ≈ 2.00 degree, and feed rate of 195.38 g/min. (shrink)