Quantum mechanics makes some very significant observations about nature. Unfortunately, these observations remain a mystery because they do not fit into and/or cannot be explained through classical mechanics. However, we can still explore the philosophical and practical implications of these observations. This article aims to explain philosophical and practical implications of one of the most important observations of quantum mechanics – uncertainty or the arbitrariness in the behavior of particles.

Among all non conventional micro machining, electrochemical discharge machining ECDM is having high quality of material removal rate with zero residual stress. This machining has been accepted as a highly modern technology in micromachining. In this paper an effort has been done on micro drilling of glass using electrochemical discharge machining ECDM . A fixed tool and a step down transformer have been used to support the steady machining to increase the accuracy of work piece. The input parameters used in (...) this experiment are voltage, concentration of electrolyte, enter electrode gap and ratio of area of electrode. MRR has been investigated over the input parameters. Feed rate and electrolyte temperature has been made constant of 3µm sec and 30°c respectively. Taguchi method is used to optimize the effect of the process parameters on MRR. The signal to noise S N ratio and the ANOVA analysis are employed to find the contributions of input parameters. Vikrant Sharma | Sunil Kumar "Experimental research to Optimize Process Parameters in Machining of Non Conducting Material with hybrid non conconventional machining" Published in International Journal of Trend in Scientific Research and Development (ijtsrd), ISSN: 2456-6470, Volume-1 | Issue-4 , June 2017. (shrink)

Electrochemical assisted abrasive flow finishing is a newly developed hybrid finishing process which is used to finish the internal parts of work piece having complicated geometry to large extent. In electrochemical assisted abrasive flow machining higher abrasion of the material was detected due to the combine effect of ECM and AFF processes. In Electrochemical aided abrasive flow machining a electrolyte is added to the prepared media .This media consist a kind of polymeric carrier and abrasive particles that are hydrocarbon gel, (...) Al2O3, Silicon based polymer, and NaI Sodium iodide as electrolytic salt. In this experimental research different process parameters such as voltage, abrasive concentration, Number of cycle, molal concentration and diameter of rod were considered at different levels for response characteristic of surface roughness Ra and material removal MR based on Taguchi method using standard L27 orthogonal array OA for the plan of experimentation. To determine the contribution of each parameter analysis of variance was used. Sandeep Singh | Sunil kumar "Experimental Research Work to Optimize Process Parameters into Electro Chemical Abrasive Flow Machining using Taguchi Methodology" Published in International Journal of Trend in Scientific Research and Development (ijtsrd), ISSN: 2456-6470, Volume-1 | Issue-4 , June 2017 . (shrink)

A collection of essays originally published in a special issue of Modern Asia Studies in March 2012, this volume comprises the interactions of various cultures including Singapore, Ladakh, Penang, and Istanbul. It also traces interactions over the sea and between various religious spaces. Businesses or inter-Asian joint-ventures are also included. Edited by professors of history, this book is a welcome addition to the scarce literature on transnational interactions within Asia.